Die integrierten Verstärker leisten 120Watt am Bass und 70Watt am Hochtöner, so dass ein maximaler Schalldruck von 115dB entstehen kann.
Lieferkosten
GRATIS LIEFERUNG innerhalb der Schweiz!
Beschreibung
The S7 is a self-powered, 2-way active monitor. Its integral electronics make it a compact yet powerful choice providing a combined output of 190 W for each monitor. It is fully magnetically shielded, so it can be used in close proximity to CRT monitors or TVs.
... The S7 is a finely tuned reflex port design. Extensive work has gone into the amplifier and active cross over, employing world leaders in amplifier design. This combination has produced a product that boasts excellent sonic accuracy with un-hyped bass exactness. EQ a jazz double bass or house music kick drum with ease.
The S7 is suited to a wide variety of applications. Typical applications include near-field monitoring for recording/mixing, programming, post production suites, broadcast and surround sound. The high power output enables the monitors to be used where high monitoring levels are required such as location work. The compact size allows for ease of placement of three or more units for LCR and multi-channel applications.
Although the bandwidth of the S7 is adequate for most situations, the low end performance can be further extended by combining it with an SB series sub bass. The two products make an ideal combination and extend the frequency response down to 20 Hz.
Specification
Size (WxHxD) Dimensions: 244(w) x 347(h) x 302(d) mm
Weight 11.7 kgs
Drivers Bass cone - 1 x 165 mm (6 ½ ")
High Frequency soft dome - 1 x 28 mm (1 ?")
Maximum SPL 115 dB (c) continuous pink noise @ 1 m (121 dB (c) per pair RMS music)
Frequency Response 65 Hz-22 kHz ± 2 dB
Input
Connector XLR and ¼ inch Jack combo socket
Impedance 10k electronically balanced with RF filters
Wiring Pin 1 ground Sleeve
Pin 2 hot Tip
Pin 3 cold Ring
Sensitivity -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear
Filters
Subsonic -3dB @ 30 Hz, 24dB/oct
Ultrasonic -3dB @ 75kHz, 4dB/oct
Crossover 1k19
LF EQ -2/-4 @ 65 Hz
HF EQ +/- 2dB @ 10 kHz
Power Amplifier
LF output power > 120W RMS
HF output power > 70W RMS
T.H.D. < 0.03% at levels up to 1 dB below clip, 20 Hz-20 kHz. typ 0.005% @ 1kHz
Hum + Noise > -100 dB referred to clip
NOTE 1: The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding
30ºC.
Indication
Power on Front mounted green LED indicates power applied.
Clip Red LED 2 dB before amplifier clip.
Power requirements
Voltage Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC
230V setting: min 160V; restricted output power: max 255V
115V setting: min 80V; restricted output power: max 127V
Consumption
Quiescent 18W
Typical use 75W (average music)
Max 140W (average music)
Note 0 dBu = 775 mV into open circuit